Macap M5 Coffee Grinder Teardown | สังเคราะห์เนื้อหาที่เกี่ยวข้องmacap m5ที่ถูกต้องที่สุด

3 thoughts on “Macap M5 Coffee Grinder Teardown | สังเคราะห์เนื้อหาที่เกี่ยวข้องmacap m5ที่ถูกต้องที่สุด”

1. 

   Mark Vejnar says:

   I found it. There’s a pin on the bottom of the shaft just like the one the top of the shaft above the nut. The bottom of the shaft has not but. The pin may be hidden by black grease. I used a brass drift to remove the pin, then remove the doser lever. There is a 4 mm (perhaps 5 mm – my metric is not so great) pin in the doser lever, and a spring behind the pin. I was able to use a small drift to remove the spring and install it in the new doser lever, and then install the 4 mm pin the the doser lever. Then it all went back together as it came apart. Fairly simple once the small pin in the shaft is located.

   All in all there are 4 pins to contend with: a small pin above the nut in the doser basket. The others are under the plastic cover held in place by three screws on the bottom of the doser. The three remaining pins include: a pin at the bottom of the center shaft similar to the one found at the top of the same shaft, a 4 mm pin in the doser, and another 4 mm pin that will be obvious once you remove the three screws holding the bottom plastic cover in place.

   21/10/2022 at 8:59 AM

   เข้าสู่ระบบเพื่อตอบ
2. 

   Mark Vejnar says:

   How do you disassemble the doser? I’m trying to replace the doser lever. I have a new lever, but cannot see how a broken lever is removed.

   21/10/2022 at 8:59 AM

   เข้าสู่ระบบเพื่อตอบ
3. 

   dorianpod77 says:

   Hi I need to remove the piece where the bottom burr is attached (4:50),I removed the top big bolt but the screw pitch rotates together with the whole piece…any help?..thanks.

   21/10/2022 at 8:59 AM

   เข้าสู่ระบบเพื่อตอบ